TECH FORUM
Add the other filter to see articles crossing "Industrial" with it.
-
Joint Heating in Quadruped Robots: How Schottky Modules Reduce Thermal Losses in Free‑wheeling Paths
For quadruped robots, drive‑stage losses contribute around 15 % of total joint heat generation. Within drivers, power‑device switching and conduction losses acc…
-
Industrial Power Supply N+1 Redundant Parallel Silicon Schottky: Can Positive Temperature Coefficient Enable Self-Current Sharing?
A frequent engineering pitfall is transplanting the self‑balancing merit of SiC Schottky diodes onto silicon‑based Schottky devices.…
-
Servo Drive Overheating Persists? Before Replacing the Heatsink, Check the Diode in the Freewheeling Loop
When a silicon-based fast recovery diode (FRD) turns off, the minority carriers stored in the PN junction require time to be swept out, forming a reverse recove…
-
Frequency and Cost Boundaries of the PFC Stage in Industrial Power Supplies
The unit cost of a SiC diode is about 3–5 times that of a silicon FRD, but in the PFC boost stage, the switching-loss savings from zero reverse recovery scale w…
-
Industrial switching power supply secondary rectification thermal challenge: How does a 0.75V on-state voltage drop reduce power loss?
Diode losses in secondary‑side rectifiers of industrial switch‑mode power supplies can account for up to 30 % of total system power dissipation, and this ratio …
-
Servo drive cooling won’t come down—where exactly is the problem?
It is not in the switching devices themselves, but in the silicon-based fast-recovery diode in the freewheeling loop.…
-
HG40T120TPX100 in Inverter Welders: Arc Strike, Thermal Management, and Lightweighting
Addressing three real pain points in 160-250A inverter welders - slow arc strike, thermal runaway at elevated temperature, and heatsink volume - the HG40T120TPX…
-
HGF200MA120X100 IGBT Module: An Efficiency Solution for Industrial Drives and High-Frequency Power Supplies
For industrial drives and high-frequency power supplies above an 800V bus, at 10-30kHz switching, with constrained cooling, the HGF200MA120X100 balances efficie…
-
The efficiency ceiling of industrial UPS and high-end PFC often comes down to a single Boost diode
Efficiency in industrial UPS and high-end PFC designs often plateaus at 94%–95%, with limited gains from repeated main-switch iterations.…
-
Given that BMS balancers inherently operate in high-temperature environments, how much of SiC’s high-temperature advantage can actually be realized?
Under the same temperature-rise constraint, SiC allows a larger balancing current to be retained, or a smaller thermal-design margin to be traded for.…
-
For Active BMS Balancing, Is the Efficiency Bottleneck in the Topology or in the Switching Devices?
In most engineering practice, switching devices are the more direct constraint. The reverse-recovery charge of the silicon MOSFET body diode creates a fixed “lo…
-
Quadruped Robot Dog Endurance Challenge: 67.7% of Losses Are Hidden in Actuators—How Much Can SiC MOSFETs Reclaim from the Joints?
Quadruped robot endurance is not solely limited by battery capacity; actuator electrical loss is a core constraint.…