TECH FORUM
Add the other filter to see articles crossing "Industrial Power" with it.
-
Industrial Power Supply N+1 Redundant Parallel Silicon Schottky: Can Positive Temperature Coefficient Enable Self-Current Sharing?
A frequent engineering pitfall is transplanting the self‑balancing merit of SiC Schottky diodes onto silicon‑based Schottky devices.…
-
Frequency and Cost Boundaries of the PFC Stage in Industrial Power Supplies
The unit cost of a SiC diode is about 3–5 times that of a silicon FRD, but in the PFC boost stage, the switching-loss savings from zero reverse recovery scale w…
-
Industrial switching power supply secondary rectification thermal challenge: How does a 0.75V on-state voltage drop reduce power loss?
Diode losses in secondary‑side rectifiers of industrial switch‑mode power supplies can account for up to 30 % of total system power dissipation, and this ratio …
-
Given that BMS balancers inherently operate in high-temperature environments, how much of SiC’s high-temperature advantage can actually be realized?
Under the same temperature-rise constraint, SiC allows a larger balancing current to be retained, or a smaller thermal-design margin to be traded for.…
-
For Active BMS Balancing, Is the Efficiency Bottleneck in the Topology or in the Switching Devices?
In most engineering practice, switching devices are the more direct constraint. The reverse-recovery charge of the silicon MOSFET body diode creates a fixed “lo…
-
IGBT Paralleling: Why “Each Unit Meets Spec” Does Not Mean “the Pair Is Consistent”
As power levels in high-power converters and UPS systems continue to rise, paralleling is the most direct way to expand current when a single module’s current c…
-
Industrial Power Supplies Burning Rectifier Diodes in the Field: The Problem Is Often Not the Rated Current
A large share of field failures of rectifier devices in industrial power supplies are not caused by undersized steady-state current ratings, but insufficient su…
-
Is 90% Efficiency Enough for Inverter Welding IGBT Modules?
When selecting IGBT modules for inverter welding machines, whether 90% efficiency is sufficient depends on duty cycle, thermal conditions, and cost constraints.…