TECH FORUM
Add the other filter to see articles crossing "Energy" with it.
-
PFC Boost Diode for 800V Platforms: Why 650V “Derating” Does Not Hold
The voltage stress borne by an OBC's PFC boost diode is not equal to the battery platform voltage.…
-
Energy storage PCS efficiency is stuck at 98% and cannot go higher—how much change can SiC SBDs bring?
In the AC/DC and DC/DC power stages of energy storage PCS, the reverse recovery loss of conventional silicon-based fast-recovery diodes is one of the key factor…
-
Why EV Charging Stations Need Dedicated Schottky Modules?
The primary cause of charging module failures is often not damage to the chip itself, but heat dissipation.…
-
Hot-Swap ORing: The Irreplaceable Role and Real Cost of Schottky Modules
Hot swapping requires that the load remain powered when a battery cluster is replaced. The ORing diode must operate passively under the logic of “the higher vol…
-
MOSFET Selection in a BMS: Four Criteria and Three Pitfalls to Avoid
A MOSFET in a BMS is the switch that executes safety actions, not an optional protection component.…
-
Single-Phase String PV Inverters: Achieving Both No-Derating at High Temperature and High Low-Light Efficiency
Generation revenue for a residential PV inverter depends more on whether it avoids derating during the hottest hours and can still generate under the weakest su…
-
Why do PV combiner boxes need dedicated anti-reverse Schottky modules?
The reverse-blocking diodes inside a combiner box conduct continuously throughout the PV power generation process.…
-
IGBT Paralleling: Why “Each Unit Meets Spec” Does Not Mean “the Pair Is Consistent”
As power levels in high-power converters and UPS systems continue to rise, paralleling is the most direct way to expand current when a single module’s current c…
-
Why Rth(j-c) Deserves a Look Before VCE(sat) in Wind Converter IGBT Selection
Wind converters present two very different thermal-stress profiles on the generator side and the grid side.…