TECH FORUM
-
Joint Heating in Quadruped Robots: How Schottky Modules Reduce Thermal Losses in Free‑wheeling Paths
For quadruped robots, drive‑stage losses contribute around 15 % of total joint heat generation. Within drivers, power‑device switching and conduction losses acc…
-
Industrial Power Supply N+1 Redundant Parallel Silicon Schottky: Can Positive Temperature Coefficient Enable Self-Current Sharing?
A frequent engineering pitfall is transplanting the self‑balancing merit of SiC Schottky diodes onto silicon‑based Schottky devices.…
-
PFC Boost Diode for 800V Platforms: Why 650V “Derating” Does Not Hold
The voltage stress borne by an OBC's PFC boost diode is not equal to the battery platform voltage.…
-
Power Supply Design for 5G Base Stations and Edge Data Centers: Why Is Saving Space More Valuable Than Saving Electricity Costs?
In application scenarios such as rooftop cabinets, street-side cabinets, and building-top sites, physical space is the scarcest operational resource.…
-
Why must telecom power supply modularization resolve the conflict between "thermal" and "frequency"?
Modular telecom power supplies require a single module to deliver 3 kW–5 kW within a 1U/2U height.…
-
SiC MOSFET Selection for AC/DC Front-End PFC in 800V HVDC Architectures: Why “Sufficient Voltage Rating” Is Only the Entry Ticket
In the AC/DC front-end totem-pole PFC stage of an 800V HVDC data center architecture, the SiC MOSFET selection bottleneck is not “whether the voltage rating is …
-
Energy storage PCS efficiency is stuck at 98% and cannot go higher—how much change can SiC SBDs bring?
In the AC/DC and DC/DC power stages of energy storage PCS, the reverse recovery loss of conventional silicon-based fast-recovery diodes is one of the key factor…
-
Servo Drive Overheating Persists? Before Replacing the Heatsink, Check the Diode in the Freewheeling Loop
When a silicon-based fast recovery diode (FRD) turns off, the minority carriers stored in the PN junction require time to be swept out, forming a reverse recove…
-
Frequency and Cost Boundaries of the PFC Stage in Industrial Power Supplies
The unit cost of a SiC diode is about 3–5 times that of a silicon FRD, but in the PFC boost stage, the switching-loss savings from zero reverse recovery scale w…
-
Industrial switching power supply secondary rectification thermal challenge: How does a 0.75V on-state voltage drop reduce power loss?
Diode losses in secondary‑side rectifiers of industrial switch‑mode power supplies can account for up to 30 % of total system power dissipation, and this ratio …
-
Servo drive cooling won’t come down—where exactly is the problem?
It is not in the switching devices themselves, but in the silicon-based fast-recovery diode in the freewheeling loop.…
-
Why EV Charging Stations Need Dedicated Schottky Modules?
The primary cause of charging module failures is often not damage to the chip itself, but heat dissipation.…