SiC Diodes, SiC MOSFETs, IGBTs & Power Modules Manufacturer | Hypersemi
TechForum - application notes and selection guides

TECH FORUM

Servo drive cooling won’t come down—where exactly is the problem?

Servo drive cooling won’t come down—where exactly is the problem?

 It is not in the switching devices themselves, but in the silicon-based fast-recovery diode in the freewheeling loop. Servo drives often operate at carrier frequencies of 10–20 kHz. Each turn-off of the freewheeling diode produces reverse recovery charge (Qrr); this energy produces no torque and is converted only into heat. When engineers try to raise switching frequency to obtain wider current-loop bandwidth, the reverse recovery loss of silicon FRDs rises nonlinearly, forcing the design back to the old balance of “larger heatsink + lower frequency.”

  The more hidden cost is in lifetime. The junction temperature of silicon devices is usually held near 150°C. During thermal cycling, thermal expansion coefficient mismatch among the die, solder joints, and substrate gradually accumulates mechanical fatigue; bond-wire lift-off is one typical failure path for servo drives after long-term operation. In one customer case, excessive Qrr of the freewheeling diode caused reverse recovery current at turn-off to superimpose on the IGBT tail current, exceeding instantaneous power dissipation and ultimately causing catastrophic device failure under braking conditions. A single diode in the freewheeling loop can consume the entire reliability margin of the power stage.

What problems can SiC Schottky solve?

  SiC Schottky diodes are majority-carrier devices with no minority-carrier storage effect, so reverse recovery charge approaches zero. In freewheeling and braking loops of servo drives, this means two things: the loss “step” during turn-off is flattened, and increasing switching frequency no longer comes at the cost of diode loss; the positive temperature coefficient of SiC Schottky diodes makes current sharing more predictable when multiple devices are paralleled, avoiding the hidden risk of thermal runaway when silicon diodes are paralleled.

  System-level benefits are more direct than single-device parameters. After replacing IGBTs with SiC modules, total energy loss of the servo system can be reduced by about 41%, and the drive’s own heat generation decreases accordingly, allowing the cooling system to migrate from forced-air cooling to natural-air cooling. Every watt of freewheeling loss removed ultimately translates into heatsink size, cabinet temperature rise, and the feasible space for compact multi-axis layouts.

For low-voltage servo DC buses, which models can directly match?

  For freewheeling and braking loops on 48V–200V-class servo DC buses, Hypersemi Schottky modules offer two differentiated selection entry points:

  HS8MBRH200N2X100: 200V / 200A, M31H package, VFM 1V, IFSM 1650A, Non‑isolation SBD. Suitable for cost-sensitive 200V servo platforms; the non-isolated package is simpler to install in bus common-ground layouts.

  HS13MBS200N1X100: 100V / 200A, M58 package, VFM 0.95V, IFSM 1650A, Isolation SBD. The isolated package is more favorable for insulation coordination in compact servo drive layouts, and the 100V blocking voltage leaves ample derating margin when matched to a 48V bus.

  Both models have an IFSM of 1650A, corresponding to the surge current impact of servo motors during acceleration, deceleration, and braking transients. For complete parameters and the selection entry point, see the product pages on the Hypersemi official website.

Back to top