TECH FORUM
-
Are the system-level advantages of silicon carbide MOSFETs in high-voltage circuits just because of their fast switching speed?
HyperSemi 1700V & 3300V SiC MOSFETs, low-loss high-speed switching devices for 1500V DC bus photovoltaic, energy storage, motor drive and high-voltage DC/DC app…
-
Servo Drive Overheating Persists? Before Replacing the Heatsink, Check the Diode in the Freewheeling Loop
When a silicon-based fast recovery diode (FRD) turns off, the minority carriers stored in the PN junction require time to be swept out, forming a reverse recove…
-
Frequency and Cost Boundaries of the PFC Stage in Industrial Power Supplies
The unit cost of a SiC diode is about 3–5 times that of a silicon FRD, but in the PFC boost stage, the switching-loss savings from zero reverse recovery scale w…
-
Industrial switching power supply secondary rectification thermal challenge: How does a 0.75V on-state voltage drop reduce power loss?
Diode losses in secondary‑side rectifiers of industrial switch‑mode power supplies can account for up to 30 % of total system power dissipation, and this ratio …
-
How much electricity is actually lost in a year when an energy storage system’s round-trip efficiency differs by 1%?
Each 1-percentage-point gain in round-trip efficiency lets a 100MWh storage station release about several million kWh more electricity per year.…
-
Servo drive cooling won’t come down—where exactly is the problem?
It is not in the switching devices themselves, but in the silicon-based fast-recovery diode in the freewheeling loop.…
-
Why EV Charging Stations Need Dedicated Schottky Modules?
The primary cause of charging module failures is often not damage to the chip itself, but heat dissipation.…
-
Why a PIM is more worth evaluating than “six discrete SiC” for inverter air-conditioner compressor drives?
Because the bottleneck of discrete solutions is not the chip but the commutation loop among the six devices on the PCB.…
-
Why Do VFD Braking Units Repeatedly Burn Power Devices: Is the Problem the IGBT or the Freewheeling Diode?
In most cases, the problem is not the IGBT but the reverse-recovery behavior of the freewheeling diode in the braking chopper circuit.…
-
Hot-Swap ORing: The Irreplaceable Role and Real Cost of Schottky Modules
Hot swapping requires that the load remain powered when a battery cluster is replaced. The ORing diode must operate passively under the logic of “the higher vol…
-
Selecting a Lithium Battery Protection Circuit: The Value and Limits of Dual-N-Channel Co-Packaged MOSFETs
A dual-N-channel co-packaged MOSFET such as the 8205 family, paired with a protection IC, integrates bidirectional cutoff plus over-discharge and overcurrent pr…
-
MOSFET Selection in a BMS: Four Criteria and Three Pitfalls to Avoid
A MOSFET in a BMS is the switch that executes safety actions, not an optional protection component.…