TECH FORUM
Add the other filter to see articles crossing "Industrial Automation" with it.
-
Joint Heating in Quadruped Robots: How Schottky Modules Reduce Thermal Losses in Free‑wheeling Paths
For quadruped robots, drive‑stage losses contribute around 15 % of total joint heat generation. Within drivers, power‑device switching and conduction losses acc…
-
Anti-parallel SBD: Oversizing It Actually Wastes Power
The default instinct for anti-parallel SBD selection is "leave a bigger margin." But SBD junction capacitance grows with rated current, and that capacitance is …
-
Servo drive cooling won’t come down—where exactly is the problem?
It is not in the switching devices themselves, but in the silicon-based fast-recovery diode in the freewheeling loop.…
-
Why Do VFD Braking Units Repeatedly Burn Power Devices: Is the Problem the IGBT or the Freewheeling Diode?
In most cases, the problem is not the IGBT but the reverse-recovery behavior of the freewheeling diode in the braking chopper circuit.…
-
HG40T120TPX100 in Inverter Welders: Arc Strike, Thermal Management, and Lightweighting
Addressing three real pain points in 160-250A inverter welders - slow arc strike, thermal runaway at elevated temperature, and heatsink volume - the HG40T120TPX…
-
The efficiency ceiling of industrial UPS and high-end PFC often comes down to a single Boost diode
Efficiency in industrial UPS and high-end PFC designs often plateaus at 94%–95%, with limited gains from repeated main-switch iterations.…
-
Quadruped Robot Dog Endurance Challenge: 67.7% of Losses Are Hidden in Actuators—How Much Can SiC MOSFETs Reclaim from the Joints?
Quadruped robot endurance is not solely limited by battery capacity; actuator electrical loss is a core constraint.…
-
50kHz as the cutoff for SiC SBDs? This rule of thumb for freewheeling diodes in industrial inverters does not hold up
A selection rule of thumb circulates in industrial VFD and servo drive design: SiC SBD is only worth it above 50kHz, and ultrafast recovery FRDs are more cost-e…