TECH FORUM
Add the other filter to see articles crossing "Industrial" with it.
-
The efficiency ceiling of industrial UPS and high-end PFC often comes down to a single Boost diode
Efficiency in industrial UPS and high-end PFC designs often plateaus at 94%–95%, with limited gains from repeated main-switch iterations.…
-
Given that BMS balancers inherently operate in high-temperature environments, how much of SiC’s high-temperature advantage can actually be realized?
Under the same temperature-rise constraint, SiC allows a larger balancing current to be retained, or a smaller thermal-design margin to be traded for.…
-
For Active BMS Balancing, Is the Efficiency Bottleneck in the Topology or in the Switching Devices?
In most engineering practice, switching devices are the more direct constraint. The reverse-recovery charge of the silicon MOSFET body diode creates a fixed “lo…
-
Quadruped Robot Dog Endurance Challenge: 67.7% of Losses Are Hidden in Actuators—How Much Can SiC MOSFETs Reclaim from the Joints?
Quadruped robot endurance is not solely limited by battery capacity; actuator electrical loss is a core constraint.…
-
50kHz as the cutoff for SiC SBDs? This rule of thumb for freewheeling diodes in industrial inverters does not hold up
A selection rule of thumb circulates in industrial VFD and servo drive design: SiC SBD is only worth it above 50kHz, and ultrafast recovery FRDs are more cost-e…
-
IGBT Paralleling: Why “Each Unit Meets Spec” Does Not Mean “the Pair Is Consistent”
As power levels in high-power converters and UPS systems continue to rise, paralleling is the most direct way to expand current when a single module’s current c…
-
Industrial Power Supplies Burning Rectifier Diodes in the Field: The Problem Is Often Not the Rated Current
A large share of field failures of rectifier devices in industrial power supplies are not caused by undersized steady-state current ratings, but insufficient su…
-
Is 90% Efficiency Enough for Inverter Welding IGBT Modules?
When selecting IGBT modules for inverter welding machines, whether 90% efficiency is sufficient depends on duty cycle, thermal conditions, and cost constraints.…