Module packaging turns VFM from a “nominal value” into a “calculable value”
DC‑DC power supply for optical modules and high-speed communication boards: don't just focus on zero reverse recovery—understand the engineering value of rectifier voltage drop
In board-level DC‑DC power supplies for optical modules and high-speed communication boards, the lower the output voltage, the higher the share of the rectifier diode VFM in total losses. Selecting devices by focusing on “zero reverse recovery” may point you in the wrong direction in this scenario. The internal airflow of an optical module is almost zero, and multiple heat-generating devices are packed into a fixed-size housing; power management components must handle higher current and more heat in the same space. Under these thermal conditions, the absolute value of VFM directly determines the conduction-loss baseline of the output stage, and module packaging turns VFM from a “nominal value” into a “calculable value,” which is more engineering-relevant than simply pursuing the lowest nominal number.
Why is the device-selection logic for “low VFM” in the context of module packaging different from that for discrete devices?
The VFM of discrete Schottky diodes is usually measured at 25℃ and a specific current. However, the actual junction temperature in optical module power supplies is much higher than 25℃, and batch variations in solder-joint thermal resistance and PCB copper foil heat-dissipation capability cause the operating point to deviate from the test conditions, so the actual VFM drifts accordingly. What designers receive is a set of off-target parameters—a device nominally rated at 0.5V may already be above 0.7V at an 80℃ junction temperature.
Module packaging places VFM and junction-to-case thermal resistance Rth (j‑c) in the same datasheet. Designers can use measured case temperature to infer junction temperature, then go back to the VFM‑temperature curve to correct the true voltage drop at the operating point, instead of making a two-fold estimate between “VFM at a nominal 25℃” and an “unknown actual junction temperature.” For space-constrained scenarios with almost zero airflow, such as optical modules and high-speed boards, this calculability directly determines whether the thermal design is done right the first time or relies on repeated trial and error with prototypes.
Which two models match?
For 200V-class output rectification, choose the lowest VFM grade in the current lineup. The HS8MBRH300N2X100 has VFM 0.75V / IFAV 300A / VRRM 200V / M31H package, and is the option with the lowest on-state voltage drop among Hypersemi 200V-class modules, suitable for output rectification or ORing paths that are sensitive to conduction loss. The 300A IFAV corresponds to a single-device or parallel architecture for high-current output stages; Non‑isolation SBD is straightforward to install in a common-ground layout.
If an isolated package is needed to simplify board-level insulation coordination, take the other entry point. The HS13MBS200N1X100 has 100V / 200A / VFM 0.95V / M58 package / Isolation SBD; the 100V VRRM matches the derating requirement of a 48V intermediate bus, and the isolation SBD has a built-in insulation structure between its base and terminals, which can reduce the additional thermal-resistance interface caused by insulating pads in layouts with tight creepage distances, such as optical module power supplies. For a complete parameter comparison of the two paths, see the Schottky module product page.
If the design involves paralleling multiple devices to expand current, the positive temperature coefficient of SiC Schottky causes on-state voltage drop to increase as junction temperature rises, transferring current to cooler branches and, by mechanism, suppressing the current concentration and thermal runaway that the negative temperature coefficient of silicon Schottky may cause. However, a positive temperature coefficient only ensures thermal stability; it does not replace layout symmetry and current-sharing verification—final confirmation of a parallel design should still be based on measured branch current distribution.